Junkrat RIP-Tire

Junkrat's RIP-Tire (from Overwatch) with attachable stand. It can also rotate on the stand!

This assembly does not require any glue to stick the pieces together but some pieces might become loose over time.

The simple cover is not necessarily needed. It was intended to make up for some of the space left over between the axis and the back side (towards the stand) but after the print I realized that the space I had measured reserved for the cover was taken up by imperfections in the print.

NOTES:

• I chose to print the RIP-Tire as two halves, then attached them together
• The tips of the RIP-Tire are quite sharp. Consider filing them down