Summary

For hanging your headphones off the bottom of a glass top desk. Glass should be 8mm thick. Clips on very securely, won't wiggle off accidentally.

Instructions

There are two STLs - one with straight corners, one rounded. I prefer the rounded corners.

The clip has a rounded entry point and takes a little force to get it on the glass - I found rocking it back and forth allowed it to slip on without too much issue.

I printed with 3 shells and %25 infill in PLA and it is very strong with very little flex. Zero worries about it breaking.

Headphone Hanger (Sennheiser 518)