Summary

Inspired by pocket83's video, I recreated the Rubik's Bricks for 3D printing. pocket83 can explain the puzzle more eloquently than I do. More information can be found in TwistyPuzzles.com.

Print Settings

Printer Brand:

FlashForge

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Creator Pro</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2 mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>The following is needed to create one set of the puzzle:</p><ul><li>1 × A.stl</li><li>1 × B.stl</li><li>1 × C.stl</li><li>1 × D.stl</li><li>1 × E1.stl</li><li>1 × E2.stl</li><li>1 × F1.stl</li><li>1 × F2.stl</li><li>1 × G1.stl</li><li>1 × G2.stl</li><li>1 × H.stl</li><li>1 × I.stl</li><li>3 × Connector.stl</li></ul><p>Note: E2.stl, F2.stl, and G2.stl are identical.</p><p>I used a no-name brand wood filament to print these.</p></div>

Post-Printing

Glue

            <div><p>I used CA glue to connect the separated cubes to the other main pieces using the connectors. Be careful not to get any glue on the outside surfaces!</p></div>                <p class="detail-title"><strong>Sand</strong></p>            <div><p>Sand all the flat areas of the pieces with 180 grit sand paper. No need to sand all the chamfered areas.</p></div>                <p class="detail-title"><strong>Stain</strong></p>            <div><p>For my project, I used a DIY coffee stain I found from <a rel="nofollow" href="http://whatelsemichelle.com/natural-wood-dye/">here</a>. Not only is it super cheap, it also smells wonderful!</p></div>                <p class="detail-title"><strong>Finish</strong></p>            <div><p>I used a cheap clear spray lacquer to coat all the pieces. It should prevent the stain from rubbing off on other surfaces.</p></div>