Dell R710/610 SFF Drive Tray

Ready to assemble Dell SFF Drive tray.

Everything was printed with 20% infill with basic settings using PLA. Modeled from the ground up using a Dell OEM drive tray.

The handle is plenty strong and allows you to pull the drive in and out easily. One rail does have a cut out so the drive can slide all the way into the back plane. All you need are 4 screws just about any should work. The handle/connector is a tight fit into the two side rails which give it some extra strength.

I had some of these laying around from a different project: http://www.ebay.com/itm/-/180999268972