Gigameter Custom Parts

Finishing parts for ERankLuck's Gigameter model. This is all very, very WIP until I've had a chance to assembly and fit things fully. As it stands, most of this is conceptual and untested. You've been warned!

Release 2 3/24/2017: Motor Base was split into Motor Shaft and Base for easy printing. Dome was redesigned to fit D-Shaft 3mm gearmotor. Dome parts successfully test fit against original model and Kit Kraft 89mm Dome.

Release 3 3/26/2017: Ears successfully converted to gear drive! Decided to write a quick printing guide, which you can find in the files and in the sketchup files .zip. I've updated the Ear and Servo mount model to clear the new ear gears, as well.

Release 4 4/1/2017: Not an April Fools joke. Two new models, left and right handle halves that incorporate a levered microswitch opening with mounting bosses, as well as a removal of the thumbwheel pot opening in the handles. At this point, all models have been tested and are on a fully assembled Gigameter. However, I will likely update this one more time to incorporate a speaker mount into the battery box cover, as it's a good place for one.

Release 5 4/11/2017: Added the speaker-grille battery box door and version 1.2 firmware for the Arduino. Also added Gigameter.winproj.zip, which is the project file and sounds required to program the WT588-16p prop sound chip used in this project. This includes the boot-up and running sounds.

Electronics ARE DONE - See the thread on GBFans Forums.

For now, I'm removing the WIP tag. I've fully built a Gigameter using these models, and it works great!