FlySky i6Xb Case

Simple case for FlySky's new radio receiver! (I printed in clear PLA)
It prints in two parts, and screws together using 2mm tapping screws.
I used 11mm length screws.
Takes about 25 minutes at .2mm resolution

Here's a 100 pack of 2mm screws on Amazon with prime shipping, if you need them ^-^
https://goo.gl/llvQvb

==Things to do==
-Make different versions for "only" PWM, i-bus, or PPM. As well as versions for each that cover the VBat plug, in case somebody wants that for some reason.
-Thicken the bottom half so the screws don't poke through