Mavic Pro Cree Strobon Mount V3

This is the new version of my Mavic Pro Cree strobon Mount, I print in PLA the Strobon fits inside the whole. There is a slot if you want to add a 2nd security of a Tie wrap to ensure it does not fall out but its a tight fit. At the bottom is a whole so you can remove the strobon with a small screw driver on the plate, be carefull not to puncture the Lipo... To turn on either before puttin in place or use a small screw driver to push against the button..

I have uploaded the 123D design files if anyone wants to adjust, I have several Cree strobon and each one is a little different in fit... the top of the mount allows for quite a flex.. and have not managed to break any by fitting..

The Clamp is a Tight fit, To mount place the smaller part against the top of the arm and bend slightly the back to fit, this on my Mavic fits well as shown in the Photos,

I have found that the badk arms are not actually square, the front is a small bit bitter then the bak top to bottom and the top and bottom slop also...