Summary

An Exoskeleton Hand allowing screwless and single part printing. I apologize for using .zip files, but the files were too big to just put the raw .stl into Thingiverse!

This is a whole remix of http://www.thingiverse.com/thing:892654 by 3DPrintIt, all credit for design goes to Alex Czech.

Print Settings

Printer:

FlashForge Creator Pro

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Infill shouldn't really make a difference, but you'll need quite a few supports, just be careful not to get them in places where you can't get them out.</p></div>

Post-Printing

Assembly (READ FULLY BEFORE PRINTING)

            <div><p>Even if you print the "Whole" models, you will still need to print out the "Wrist Lock" as well.  I recommend printing the "Finger 2" and "Thumb 2" files if you don't have a big enough print bed for the whole thing.  In that case you will have to make sure to print 4 "Finger 2" files, and 1 "Thumb 2" files, and putting them onto the "Back Left/Right" during printing.</p><p>If you don't want to worry about putting them on mid-print, then print 4 "Finger" files, and 1 "Thumb," as well as 5 "Finger Pin" files.  Assembly should be pretty straightforward from there.</p></div>

How I Designed This

I took the files from the original model, scaled a few up, rotated some, and put them together to form a whole hand.

Exoskeleton Hand - Whole (Untested)