TX Flysky i6 hand PAD

update : I found the PLA a little bit slippery, don't have yet TPU or flexible filament, so I sprayed them with Rubber Leakseal. The Pads hold better on the TX and especially hands too !

Here's a set of hand pad that I created to hold well this thin i6 transmitter from Flysky.
I printed them without any support, standing, be careful there's not much touching bottom layer, you can try adding manual support.

Polygon look is wanted.

Designed more for Thumbs Pilots, maybe the configuration is not the best for Pinching.

I drilled holes on my tx with a 2.6ish mm mesh than screwed metal 3mm hex screw.

If you want to try first, I could imagine first print it as vase mode maybe.

More about my design process here http://drones-xp.blogspot.ca/2017/04/3d-print-hand-pads-flysky-i6.html