Summary

This is a print in place 1x2x3 Rubik's cube!

Print Settings

Printer Brand:

Printrbot

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Printrbot Simple Metal</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2 (0.1 would probably be better)</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>5%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>It is printed on its side, so that the top and bottom 1x1x3 layers are separated by a layer of support material. Note that the support material between these two layers is quite hard to remove. I had to put a nail between then layers and hit it with a hammer. The support material should be set to "everywhere" or an equivalent depending on your slicing program.</p></div>

How I Designed This

I used tinkercad to design this puzzle. There are hooks on the outer 1x1x2 blocks to connect into the inner 1x1x2. There is a y-shaped piece in the inner 1x1x2 to connect the two pieces together.

Another Print-in place 1x2x3