Nozzle Cooler for Leapfrog Creatr Dual extruder

Inspired by the nozzle cooler by Zabana.
Because I could only find the one for a single extruder, I decided to design a cooler which will cool both nozzles.

Part 1, 2, 3 and 5 can be printed without support.
Part 4 has to be printed with support.

First place part 1 and 2 from the back around the extruder block with part 1 on top. (Do this careful around the cable connectors of the stepper motors)
Then insert part 3 from the back until it clicks in place.
Part 4 can be glued on part 3 if necessary.
The cooler is designed for a 60x60mm fan. With a 50x50 fan the airflow is a bit too low.