Funky Candle Holder [f3d-2]

This funky candle holder, or small sculpture, was designed in Project Shapeshifter (Autodesk). Squares are the primary geometry and spinning around the Z-axis is the primary motion. One end is closed to form a thin, solid base.

This is my 2nd full design using Shapeshifter but my 1st one [f3d-1] came out better. I rushed this one and made mistakes.

Dimensions: 130mm H, 125mm W (top); 60mm W (bottom); and 30mm W at narrowest point, which is ~20mm above the build plate.

Note: You must pay special attention to the wall thickness. If you print with thin walls and/or low quality, a fatal structural weakness gets exposed at the thinnest section. (2 shells on Normal was too weak for me).