Summary

I could not find any good ways to mount my RAMPS electronics on the top of a Prusa, so I made one.

Instructions

Print two. You will also need:
6xM3-20
6xM3 nuts

The nut traps are intended to be pressure-fit. I pushed nuts into them with a pair of pliers before mounting the clips on my bot. This ensures the nuts do not fall out and get lost in the future. The clips are a tight fit on the frame and cannot be moved left and right, but do allow the RAMPS board to be swung upwards so you can run wires under it.

The RAMPS 1.4 board has only three mounting holes; on one clip you will use both holes and on the other clip you will use just one.

Top of Bot Prusa RAMPS Mount