Fidget Spinner - Hoverboard / swagway

Things needed:

Board (qty 1) - either board will work the revised board is a little longer and has a snugger fit on the axle

Axle (qty 2)

608 bearings (qty 3)

Rev 2: I tightened up the center bearing hole clearance. The bearing fit gets a bit loose after breaking it in. will make it a bit more difficult to assemblebut overtime I think it will last longer.

• Made 1 Tri version you'll need another bearing and 1 more axle

• Designed a skateboard version: http://www.thingiverse.com/thing:2310966
  added thumb pads

-revised axel to make abit shorter and made bearing fit a little looser some bearings were very tight fits