Summary

Fun spinner with a printed bearing.
Print Settings

Printer Brand:
FlashForge
                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Creator Pro</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.20</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print two of the Grip Half piece.  Join the two halves with a short length of filament (about 4 mm) for alignment.  Scrape off any excess plastic and sand the grips and bearing race until it spins freely.  Make permanent with a small amount of super glue at the center, not enough to flow to the bearing race.</p><p>Jam 1/2" nuts into the holes and glue if necessary.</p><p>Spin, spin, spin!</p><p>NOTE: I will put up an M10 nut version soon.  Metric prices are outrageous here so I only bought 3 metric nuts for sizing.</p></div>
Tri-Nut Spinner USA
