iPhone 5 Tabletop Stand

This stand allows your iPhone 5 (in a Mophie case) to be propped up at an angle in landscape mode to sit on your bedside table at night. The cradle might support other iPhone variants as well with or without cases (haven't tested any other phone/case combos.)
I have a taller/wider holder design for iPad Mini (possibly full size iPads as well) so look for this design under my username.
Design is very strong but uses relatively little plastic due to structural girder-like design with fillets at intersections.
Easy to snap off supports are integrated into the design (they are not shown in the rendering above) to allow the horizontal beams to print in the air above the printing platform in both .thing and .STL files. Highly recommend using a raft if you are going to print directly from .STL.
Normal print settings were used in Makerware (rafts option checked, do not check the box to have Makerware add additional supports!)