Summary

Android Driedel.
I took the Droidel by mishugana, cut it in half, and added a handle.

Unfortunately it doesn't spin very well. It may work better if you give the body a higher infill.

Instructions

Print the head, body, and stem, then super glue them together with the round part of the stem sticking out the top.

I split the head and body into separate parts so they could be printed flat side down. I printed both with supports because the head has a small lip that needs supporting and the letters on the body are raised.

I printed the head and body at 10% infill, but I think the body is too light. I suggest a high infill for the body and some extra shells for good measure.

The stem needs just a little sanding to fit into the square hole. I made the hole in the body too deep, so you should glue the stem at the desired height in the head before gluing that onto the body.

Droidel Remix (with handle)