Summary

This is a replacement/upgrade servo mount for the Hobbyking X900 Tricopter. I wanted a mount for slightly larger micro servos. This way you can use servos with better torque and durability compared to sub-micro servos the model's mount was designed for. I've sized it around a Futaba S3102 metal geared servo.

There are two models: One is standard (pictured) while the other has a recess.

Print Settings

Printer:

XYZ DaVinci 1.0

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>400 Microns</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>The recessed model may require supports for printing depending on print orientation.</p></div>

Post-Printing

Installing the Servo

            <div><p>To install a servo you'll most likely need to remove the bottom cover so you can fish the input wire straight down when sliding the servo in and then reinstalling the bottom cover. This allows for less length in the part for sliding the servo in at an angle.</p></div>

Hobbyking X900 Micro Servo Mount