Summary

Spinning Gyroscopic rings fidget toy.
customised in solidworks 2016.

The ring clearance and the pivot clearance are seperate dimensions.
customising the design for yourself in solidworks should be quite easy.

Print Settings

Printer Brand:

Prusa

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Prusa Clone</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.3</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>0.1-0.3</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Rings Seemed to spin better with less infill.</p><p>I printed two, one with 0.1 infill, the other with .7<br>the .7 felt nice and weighty, but the 0.1 spins for longer.</p><p><em>UPDATE</em><br>.7 infill is now spinning just as good if not better than the 0.1 infill, probably just needed more time to wear in.</p></div>

Post-Printing

Tight

            <div><p>The pivot points work best if they're nice and close together.<br>the ones I printed were just touching at one point in one layer at the pivot points.<br>This does mean it'll be a little stiff just after printing, but after moving it around, and with the help of some compressed air, it loosen up very well.</p></div>

How I Designed This

Customised

            <div><p>I wanted to separate the clearance values between the rings and between the pivot points.<br>This was due to my prints from other versions, with either the rings being too close together and rubbing on each other, or the pivot points being too loose.</p><p>The overall size of the rings was made to suit my hands.</p></div>

My Gyro Rings