Summary

Holds three 2oz Mercury Adhesive Bottles and one bottle of accelerator. Hollow base reduces filament needed.

Instructions

Printed at 0.3mm in PLA on Mendel90. I printed it upside down so that the top surface of the finished part would be smooth and flat. I did have problems with the large/long bridges on the bottom of the bottle cavities sagging. I fixed it by warming the sagged portion with hot air and pressing them flat. Adding break-away support pillars would have prevented this. Alternatively could have left the cavities open and printed separate caps that glue on the cavity bottoms.

Glue Bottle Holder