Summary

This holder is intended to hold spools with inner diameters of 30-70mm. The width is actualy depending on the length of the threaded rod you use.

Instructions

To printe the cones place them on the side with the 25mm diameter not the triangular side. Set the settings to print supports and there you go.

When you printed 2 cones plus the base you also need to get you the following parts:

4 bearings type 626
3 nuts M6
1 wing nut M6
1 washer for M6
1 threaded rod M6 length what ever you need I used 150mm and its more then sufficient

assmeble the thing in the following oder