Summary

SCAD file to make a vertical x-axis x-carriage or one for Makerslide.
The side mounting holes can be used for a fan or my auto-bed leveling servo mount.

3/10/16 - Added using a BTouch on the extruder plate.

Instructions

LM8 = uses 3 lm8uu bearings
MS = makerslide, two parts
EXT = extruder plate - use ABS for this part
MSBELT = if you run the belt on top of the makerslide
LM8BELT = set for the belt position of the vertical x-axis at http://www.thingiverse.com/thing:12609
The vertical x-axis is set for 70mm.
Makerslide wheels against the MF part with just a washer, and a 22mm spacer on the other. The adjusting nut goes on the front at the top. Uses 50mm screws. The four holes in the rear piece are for the tensioner: http://www.thingiverse.com/thing:211344
Makerslidespacer.scad file is to make a spacer for the above tensioner. Just set it for the thickness needed.
The holes on the top & bottom of the MS & LM8, and on the sides of the EXT are sized for a 3mm tap.
The last four scad files are included so you won't have to go find them.

Vertical X or Makerslide X Carriage