Summary

This allows you to display holograms made with the LitiHolo kit (www.litiholo.com). All you need to do is laser cut the holder, glue it together, and add a laser.

Instructions

This should probably be laser cut starting with a piece of 10" x 5" of 1/8 inch acrylic. Glue the Laser Holder and Plate Holder pieces in to the main part of the holder. There is a small hole in the Laser Holder to attach a laser. I suggest the following pieces from AixiZ (http://www.aixiz.com/):

635nm 5mW Laser Module 12x30mm (AH635-5-3-12)
12X30mm aluminum mount for AixiZ 12X30mm units (AIX-ALM-MT-1)
AixiZ Power Adapter 3.2VDC Output; (A-PS-32-500m)

You also need a 1/2" 4-40 machine screw, nut, and lock washer to hold the aluminum laser mount to the Laser Holder.

Use tape to seal up the bottom part of the hologram holding slot.

Hologram Display Holder