Summary

We use our Makerbot Replicator so much that we began needing several SD cards to keep up with demand. This started looking a bit messy, so we used the printer itself to fix the problem. Nice!

Instructions

Print the model then remove the screw on the lower right of the Makerbot front panel. Push this screw through the hole in the caddy and reattach it to the Makerbot. There is a tab on the right hand side which will prevent the caddy from rotating (although it seems that the force from the screw is more than enough to stop this from happening anyway).

V1: This version has a thick back plate (2 mm) and requires the stock M6x8 screw to be replaced with M6x10 screw in order to mount to the Replicator.

V2: This version has a thinner back plate (0.8 mm) that will hopefully allow the stock M6x6 screw to mount this to the Replicator (let us know if this works!).

Makerbot Replicator 2 SD card caddy