Summary

This is a Slingshot for plush 5-inch Angry Birds. Can be used for smaller ones.
Print Settings

Printer:
Anet A8
                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25% </p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Only the back of the handle requires some support. I was able to print it without a support at .2, but it had some rough texture in the back of the handle that needed sanding.</p><p>When printing the sides, just print the second one in mirror image so you have a left and right.</p><p>The bolt and nut were printed at .1 with 50% infill.<br>But the bolt and nut are tight and will most likely just turn enough to tighten the side to the handle.  You can use a regular nut and bolt to fasten the sides to the handle if you have problems with the printed ones and probably better off if you have a strong child.</p></div>
Angry Bird Sling Shot
