Summary

Just for fun, just jam them into the soft part of the opening. the pumpkin took me about a half hour to carve and is less than 8" tall so you will note the teeth are pretty large. I scaled the incisors up and down 5% at a time to vary the size and so they didn't look all the same.

Print Settings

Printer Brand:

Prusa

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Prusa Mk2</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.15 mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I didn't raft this but you could, it was very well secured to the bed with a brim.</p></div>

Pumpkin Teeth