Door stop and latch for Wanhao Duplicator 4X

I fitted the top cover and door on my Wanhao duplicator 4X this weekend. I noticed that the door did not stay open and it could go inside the printer when closed.

So I did a quick design to fix both issues.

I printed them at 0,2mm and 30% infill, they work well.

I used some cheap double sided tape that has a foam centre to fix them to the printer. I tend to use this stuff for attaching stuff to RC planes and helicopters. In this application, it allows some springiness as the PLA is quite rigid. The door stop could have a little piece of rubber glued to it to soften the blow when closing the door, but in general I suspect this would be overkill as the acrylic sheet is quite thin and light.