Build Your Own BAN HAMMER

I've wanted a BAN HAMMER for my desk for a while now, but couldn't find any on Thingiverse, so I made on in TinkerCad.

There are 3 parts:

Hammerhead - the main hammer head, with BAN written on both sides and a slot in the bottom for the handle.

Handle-section - section of handle with connectors on both ends (Probably want to print 2 of these)

Handle-base - section of handle with connector on one end to use as the base of the handle.

I haven't printed this yet, but will try on the Afinia H-series this week.

UPDATE 3/5/14 - So I printed these out. The head prints fine, but the connectors are all the wrong size. Edited the handle section and base to have a smaller male connector, which should fit better into the female connector slot. Uploaded these new files as 'v2'.

Added a few photos of the final print. Turns out, I only needed 1 of the 'section' handle pieces. Otherwise, it's a REALLY long handle. The connectors are still a tight fit, and may break off if you're not careful. At some point, I may make the hammerhead larger, but for now, this is fine.