Summary

This is designed to allow mounting of the Qu-Bd OneUp or TwoUp controller board to the power supply.

Instructions

Parts Used:
6ea #6-32 (or M3) Screws (2ea 6mm, 4ea 10-12mm)
4ea #6-32 (or M3) Nuts
1ea Nylon Washer (may not be required, but may keep screw head from shorting the reset switch)
2ea printed parts (I used basic .3mm settings)

pre-thread the holes by running the screws through beforehand
use the Nylon Washer on the screw by the reset switch
mount the controller to the top shell of power supply (use side-holes for through-hole on one end, and middle holes for through-hole on the other end)

Qu-Bd OneUp/TwoUp Controller Board -> Power Supply bracket(s)