Halloween Unicorn Mask (remixed for 5mm LED)

Printing time: ~8.5h (with the last 30mins for the horn)
Filament: ~25m (~35m with support)

I made these for some collegues, and they all wanted to keep the printing pattern and no sanding. So I painted it with acryl purple and black on the inside. Although the inside turned out as a bad idea xD

The mask is printed with the horn pointing upwards, so you can change filament to transparent.. (read notes below)

This version has a 5mm LED mount, with an extra cable hole and a CR2032 battery mount.
(essentially 3 holes, 6mm for the led, 20mm for the battery with a 2mm cable canal)

The LEDs are RGB color changing 2pin 3.3v versions, with a chip that does the mood light.
The batteries only have 3v but it's enough for a cool effect. link

Check out the video of a prototype: https://twitter.com/cccfr/status/933030858650419200