Christmas Tree Stand for Ikea Ledberg suitable for 1913982

I printed the Christmas Tree of the following thing:

https://www.thingiverse.com/thing:1913982

IMPORTANT: I haven't made this tree, the tree was made by idig3d you can find under above link!

As I was quite happy with the result and wanted to use it as decorative light and had a cheap (€5) Ikea ledberg here I quickly made this simple holder for it.

As the tree is under a license that is forbidding remixes I cannot make any adjustments to it to hold the tree somehow.
If you have pets or kids you may want to glue it to the tree ;-)

There are no special printing requirements as it is designed to give the lamp a little lose fit.
I printed it with 0.2mm layer height and 60mm/s, 10% infill on a CR-10.