Summary

Hello all,
These are parts for thing:231205 by peddiparth.
Motor mounts have 25mm spacing.

see instructions for more info!

Instructions

parts list.
3x 1/2" wooden dowels. my front 2 are cut to about 14 inches and the aft is about 12 1/2. you can change the lengths if needed...

10x #6 32x1in machine screws (got mine at home depot) they come with nuts but I bought locknuts and washers which is optional. I would suggest using Loctite at the very least.

super glue

2 bearings 5x13x4 (I,O,W)

1CF tube or rod, aluminum could work, 5mmx50mm

ball links and pushrod for tail.

electronics I used are:
exceed rc rocket series 3010-1100Kv motors (lots of power)
20A escs (got mine from quadrysteria but had to reflash with a different version of simonk)
KK2.1 flight controller
3S 4000mah 30C lipo
digital metal geared servo for tail, 9-11g is fine.

The battery tray is glued together, spacers are not glued on.
The tail is a little more complicated.
insert 1st bearing into motor mount, put plastic spacer onto CF rod and slide it on until there is 4mm of CF rod sticking out, insert the 4mm into the bearing in the motor mount. NOTE: if the spacer is not a VERY tight fit, add a very small drop of glue to hold it on the rod.
slide the other bearing onto the other end of the tube and press into motor mount, it should be flush. slide the tailcap onto the CF rod and press against the motor mount, glue the tailcap onto the motor mount, this holds the bearings in! the spacer in turn holds everything in place..... drill a 35mm deep hole into your dowel that you are using for the tail (straight and centered as possible). I used an 11/64th drillbit I think, it is just under 5mm but makes the CF tube a friction fit so you don't need to glue it in. Press the CF tube into hole (make sure your tail servo mount/gear is on first) and leave about 1mm of clearance between the two. add the servo and pushrod and go fly! you can tap that yaw mount into the boom with a hammer if needed!

Tricopter US 1/2 booms