ToolTote

** ToolTote

The ToolTote is designed to have a complete set of tools, for around the house use, in the smallest space possible. Tools are positioned with the working end up so it is easy to find the tool you need.

Screwdrivers is designed to hold these common Craftsman Screwdrivers:

Slotted:
3/32 x 1 1/2 #41541
1/8 x 4 #41589
3/16 x 4 #41581

Phillips:
P0 x 1 1/2 #41542
P1 x 3 #41294
P2 x 4 #41295

An extra hole is provided for a larger driver (Point Down) and a wall to hold a small measuring tape.

Pliers is designed to hold 5 Pliers, should fit most Plier Sets handles

Drill-Driver is designed for a Bosch 12v Drill-Driver. Most Drill-Drivers with a 1/4" Hex drive extention should work. It has holders for extra 1/4" Hex bits, drills and extentions.

Parts Holder is designed with a cup to put loose screws in, a drawer for holding some extra screws, a place for a torpedo level, a small flashlight and 2 Pencil holes.

T Handle has a hole for a pencil, marker and small utility knife. If you need a hammer, carry it in your hand while holding the handle.

Blocks and Handle were designed for a small print bed or you can combine all the parts into one model and print the whole thing as one piece. If the blocks printed seperately, you can glue them together or better yet, drill throught the back of each Block (throught Handle) and bolt together. Wells have been included in Drill-Driver Block to allow room to fit nuts on the end of bolts.

CAUTION: Since all the tools are point up, be careful not fall on ToolTote or you will be stuck with all your tools.