Werkzeughaltersystem, toolbox for screw driver flat 8 mm / 170 mm

Servus,

This here is the holder of a BIT screw driver mit flat 8 mm / 170 mm

I got me here made ​​a complete system for tool holder. I do not like when the tool is loose in the case.

So now I have a separate holder for each tool creates. This holder can be screwed onto a plywood board now. (Spax 3 mm). Holes for the screws are integrated.

I then installed these plywood panels vertically with U-profiles in a Tanos Systainer http://www.systainer.de. On an area of ​​300 mm x 400 mm I get so below about 60 tools (screwdriver, wrench set, pliers, electric tester ...).

I have the created in Catia V5. If someone original files needed, please contact me.

I have the drawing for the trigger with published (radius dimensioned). Maybe fit a different tool as well.