Werkzeughaltersystem, Gabelschluesselset, Toolbox for spanner set nach DIN 3110

Servus,

This here is the holder Set of spanner set (Type: DIN 3110). When one and use it requires no space. It is within the holder.

Size:
6-7
8-9
10-11
12-13
14-15
16-17
17-19

I have the drawing for the trigger with published. Maybe fit a different tool as well.

For load / unload the tool must be slightly tilted. So you need space for load / unload (look at the picture).

I got me here made a complete system for tool holder. I do not like when the tool is loose in the case.

So now I have a separate holder for each tool creates. This holder can be screwed onto a plywood board now. (Spax 3 mm). Holes for the screws are integrated.

I then installed these plywood panels vertically with U-profiles in a Tanos Systainer http://www.systainer.de. On an area of 300 mm x 400 mm I get so below about 60 tools (screwdriver, wrench set, pliers, electric tester ...).

I have the created in Catia V5. If someone original files needed, please contact me