Summary

A simple 40mm fan mount for the mendel 90.

Instructions

This thing prints as two different objects (there are two stls, one left, one right).

These slip into the holes that are on the x-carriage bearing mount (the side with a single bearing), then the "Wings" fit under the cable tie that hold the same bearing.

I've printed it, and slides in quite nicely.

Update: Insert slightly too large, reduced by 0.3mm, "Wings" slightly too thick, reduced by 0.2mm, made support bits a little larger.

Update: Repaired models in netfabb prior to upload

Update: Subtracted the space around fan blades in the mount, made the body wider.

Update: made the wings a little beefier

Update: final working version "up", will upload photos shortly.

Update: Photos up.

Simple Mendel90 Fan Mount