Samsung remote holder w/o screws version 2

I created this version 2 of the remote control holder without screws for more surface area for the double sided sticky tape.
This thing is more easily to mount flush under the edge of a table.
I changed the design a bit to print it on the back without the need of supports.

Print Settings

Infill: 20%

Raft: no

Support: no

Layer: 0,2mm

Nozzle: 200°

Bed: 60°

Used Filament:
http://amzn.to/2lzVd9q

Super sticky tape (fully removable and really strong):
http://amzn.to/2CA0cRN

I always use the following tape on my CR-10:
http://amzn.to/2zXjJGu
This stuff is really great, no extra glue needed, 100% sticky to the printed parts, which come off really easily, even without destroying the tape.

Have fun!

(Amazon Affiliate Links)