Rubik's Cube Stand (General Cube Stand)

This is a stand that is only 1.125in tall and has 4in sides as the base. Concave at the top to a 20 degree draft angle to allow the cube to center on the stand.

Fits large sizes to a point as long as the center of mass of the object is relatively close to it's geographical center.

For a general stand there is also a 0.5in tall and 3.25in side stand. Concave at the top with chamfered edges and a 45 degree draft. The thickness is also reduced for fast printing

RubiK's Stand is the general fit Stand (45 degrees 3in wide)

PCG Stand has the 20 degree sharp angle