FiishTank: 16x16mm FX805 Camera Mount

This is a camera mount for the FX805 camera on a 16x16mm stack drone. I use this mount on my Fiishtank 2s build:
https://rotorbuilds.com/build/8061
The camera was from https://www.getfpv.com/fx805-micro-fpv-camera-5-8ghz-37ch-25mw-vtx-with-mounting-case.html

V5 was created to be printed in SLS Nylon. I've it sent off to 3dhubs.com and the results were awesome! V5 is probably not a great print with FDM due to the elevated base, but let me know if it works out for you. V5 should remove the need for spacers and extra nuts to secure the mount to the quad, if you use an m2 tap to add threads.

And of course a big thanks to fishpepper: http://fishpepper.de/2017/07/28/how-to-build-a-2s-pepperfiish-beast-shopping-list-recommendations/

Version Notes:
V1's fitting was too tight.
V2 was pretty good, but the roll cage was way too tiny.
V3 adds a .5mm offset on the rear rib to place my polou vreg, it raises the cam box a bit, and it beef up the roll cage a lot. V3's fit was good, but the camera box was a tad too deep.
V4 shrinks the camera box depth by .2mm, shifts the angle supports, and adds a hole to save weight. V4 had a better (snug) fit on the camera, and is .2g lighter than V3.