WLtoys A959 - A979 - Front Lower Suspension Arm

Printed in PLA, 4mm shell thick and 1.2mm bottom and up layer. 100% infill. I tested and works perfect, no difference with the original one. In case you brake it, just print another one in a few minutes ;-).

Please, post a picture if you make this part. Thank you!

21/01/18
Modified original design to make it a bit stronger.1 mm thicker than original but fits perfect.

07/02/2018
Redesigned to make it even stronger because I always break it on the triangle shape hole. Removed circle hole and moved the triangle a bit away.
PLA and ABS are quite weak if you run into something and hit with the front wheel. Testing now with Nylon.