AR Drone 1.0 Replacement Landing Gear

I landed hard on the ground last fall and snapped off one of the landing gear. I tried to glue it back on but it only took a little harder then normal landing to snap it off. I found the landing gear by Pink_Iguanas but could not figure a good way to glue it on. I made a snap on piece for the cross beam and then added the flat top at the exact height to make the drone level. I printed them as one piece but found that the support messes with the ability to snap on. So i split the 2 and glued them together after printing.

UPDATE This WILL work with 2.0 as well. I have verified this.

DISCLAIMER Please note: I made the clip to be very tight. If you want to take it off do so with care. If you force it you may damage the cross beam and i have not seen a 3D printable version of the cross beams.