Summary

This is a remix of another remix I did a few weeks ago. Instead of having separate tenting, I incorporated tenting directly into the let's split case, which makes it a lot more sturdy (if not only because there's a ton of material down there). feels a bit better than the previous setup, though I would like to do something about wrist rests...

Note that you will need at least 4 (preferably 6) M3 bolts, just like with the remix and original cases

Print Settings

Printer Brand:

MakerGear

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>MakerGear M2</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.3mm is fine</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20% is fine</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>A relatively easy print that takes around 3 hours per side on my machine. You could try to align the layers with the top of the case, which would give it a better top finish, but it screws in just fine with them unaligned and it looks rather nice having the layer lines parallel to the desk.</p></div>

The Wedge - Let's Split tented keyboard case