Sliding drawer Long remix

Remix of Sliding Storage Drawers by Intentional3D.

Longer, Slimer version made to be printed in multiple parts so as to:

• Be able to print a bigger Storage drawer
• Use multiple colors without use of a dual extruder setup
• Better control Time and Quality of the print, It's no longer Hit or Miss

Exterior Size: 204x65x948 mm - 8.00x2.55x37.32 In

Difficult and/or time consuming supports are delivered in the .stl file (hexagonal pillars), you only need basic supports for the Sliders.

Need Acetone Soldering or any solid glue for assembly.

I designed this remix with the intent of making a longer, slimer version that could use my printing bed size to it's fullest.

The original craft was taller than wide due the the sliders, it mean your 1 part craft is going to be limited in Z size even though you could go wider in X-Y axis.

So i propose to make it into a multiple part craft. I even used the diagonals of my bed at 120% scaled size at a 35% Z angle. This setup is the biggest a Prusa I3 can go, using 24 out of the 25cm wide X Axis.

Other arguments to be made out of a multiple part crafts is that you can use multiple colors with a single extruder setup, and can better arrange your time. instead of a 36h craft that can miss even at the last 5%, you have smaller crafts with less supports, all printed flat on bed for an easier print.

Howerver keep in mind you'll need some simple Post-Printing soldering.