Summary

I printed this in ABS with excellent results. Just a slight sand on the flats that fit into the potentiometer to get a snug fit so it wouldn't fall out.

Print Settings

Printer Brand:

Airwolf 3D

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>AW3D HD</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.135mm 1st layer, .1mm layers, 2 perimeters, 60% infill triangles</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>60% Triangles</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I used a .4mm nozzle, slowed it down to 30mm/sec, I used upper range of temp for good layer bonding.</p></div>

Post-Printing

Sand to fit snug

            <div><p>I made the stem slightly oversized so just a light sanding to get a nice snug fit into the potentiometer.</p></div>

Weller soldering Station Temperature Control Knob