Parametric Coffee Scoop and Tamper

I wanted a coffee scoop and tamper set to match the refillable K-Cup's for my Keurig. Most of the tampers I found on Thingiverse were too big. All dimensions are customizable in the SCAD file - or just set the variables for your desired serving volume and outer scoop radius. You can also configure how tightly the tamper will fit inside the scoop (for storage) and how the tab is dimpled for a grip. I printed the scoop upside down without support and the bottom (printed as the top) bridged pretty well on my printer without supports and with a little clean-up inside afterwards. If necessary, you can want thicken the walls (there is a variable for this) to allow for some clean-up without breaking through the bottom, but I did not need this.

Enjoy the coffee!