LiPo case for electric Longboard

Hey there, I've made myself a case for my 6s LiPo setup. So there are 3 parts in this whole case.

Starting with the case itself. The Case itself is made for 2x Turnigy 3S 5000 mAh 30C LiPo
packs. There should be enough tolerance in this case. (I'll print it this week, so I'll upload more information about it later). Also I made a small space for the cables in front of the LiPo Packs.
I'm using a XT-90 Connector and a 6S Balance connector output. If you want a XT-60 please PM me with the measurements so I can upload one case with it.

The dimensions of one LiPo Pack:
149mm x 49 mm x 27mm

Now for the case cover:
As you might have seen, there are 8 total holes which are 3.5mm in diameter. You have to buy some Woodscrews to screw the case on your board. The other side has a small attachment to hold the case on the board, like the other holes this attachment has also 3.5mm holes, which are made to screw it on the board.

In total you will need:

• 10 Woodscrews with a dia. of around 3 - 3.5 mm
• Silicone
• Glue (epoxy glue)

UPDATE (30.03.18):
I've cut the parts so you don't have to. All parts are now ready to print on a normal build plate! Have fun!

WARNING!!!!
The Case has to be glued together in the end, also you have to seal every small gap with silicone to get rid of any water, while you're driving.
Also I'm not responsible for any damage made to your Board or your LiPo-packs!
Printing and using this case is in your own responsibility!