3x3 inch magnetic planter w/ magnetic catch tray

This print uses:
-around 200 grams of PLA filament
-9 generic ceramic ferrite 18mm circular magnets
-Hot glue to hold the magnets at the correct depth

This magnetic planter has a 3 by 3 inch by about 3 inch deep interior for dirt, and has a water catch tray and name tag. I used generic 18mm ceramic magnets, and used hot glue to hold them in place.

I've also attached a version of the planter without the name tag slot, since the name tag hole leaves visible lines which might not be desired if not using it.

The catch tray has a magnet at its top to connect to the magnet at the planters' bottom. 5 magnets are on the back of the planter and 2 on the back of the catch tray, which holds it securely to our metal door. Ours does not move at all when the door is slammed, but heavier soils/bigger plants might change that.

Be careful with magnets, and keep them away from children.