Summary

I've made some changes to the hololens mount here to better suit our needs.

Print Settings

Printer:

Anet E12

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Printing the fastener on it's side will increase it's strength some.</p></div>

Post-Printing

Assembly.

            <div><p>The fastener must be carefully flexed to insert into the slots.  You could heat up the fastener with hot water or a hair dryer to avoid breaking it.</p><p>Tolerances are very tight.  You can modify the file for your needs or file down some of the surfaces if need.</p></div>

How I Designed This

Several iterations to beef up and allow for locking the clip in place

Hololens Hard Hat mount (remix)