RAMPS baseplate for prusa i3 (easily removable)

This baseplate allows you to mount the arduino mega2560 with ramps board to the side of a prusa i3 (or any other printer with a big flat surface).
There are four holes that you can use to mount the mega2560 to the baseplate and two index pins because I found the space to use a screw here too limited on the mega2560.
Please check if the screw near the power connection doesn't short circuit, or leave it out.

It is mounted with two keyhole shaped holes that allow you to easily remove it.
I have already added some holes in the baseplate sides (20mm deep) to allow for any extensions/furter enclosure in the future.