Inductrix Frame w/ Motor Brace (H36, F36, e010 FC)

Inductrix frame and motor brace designed for these flight controllers

Furibee F36
JJR/C H36
Eachine e010
Flight Controller

COMPONENTS I USE

Boldclash 18000KV 615 Coreless Motors
Inductrix FPV Props
JJR/C 3.7v 150mah LiPo Batteries

I use my Furibee TX/RX and I have not looked into other binding options yet for other radios.

WEIGHT- PRINTED WITH PLA

Frame (without motor brace)- 5.1g

Frame + Motor Brace- 5.7g

Everything (Frame, Motors, Props, FC, Motor Brace, Battery)- 22.5g

Everything w/out Battery- 16.9g

TIPS

To fasten the FC board to the frame, I held the tip of my soldering iron to the phillips head of the screw, while slowly screwing it in place. The heat generated from the iron will soften the PLA and form a perfect set if done correctly.

I used a hot air rework gun to soften the PLA when installing the motors. Alternatively, if you have a tight fit you can roll up a small piece of sandpaper and sand down the ID of the motor mounts.

Show your makes! Feel free to friend us on social media and show us your makes there as well!
Google+
YouMagine
Facebook
Hackster
Arduino

Shout out to CharlyOne for the original design.